You can easily build containment in the middle of an existing slab
Building a secondary containment structure in the middle of an existing facility is very common and effective way to protect the facility structurally as well as protect the environment. It is very easy to do. Here is how:
- Grind the area where the curb will go to bare concrete – www.epoxy.com/surfaceprep.aspx.
- Drill holes into the concrete and fasten #4 bar into the concrete with Epoxy.com Product #2006 – www.epoxy.com/2006.aspx – Gel Adhesive. Allow Epoxy to cure overnight.
- Form the area to receive concrete curb.
- Coat the floor area in the bottom of the forms to receive the concrete for the curb with Epoxy.com Product #2007 – https://www.epoxy.com/Epoxy_Fresh_Concrete_to_Hardened_Concrete_2007.aspx – Wet to dry concrete adhesive. Pour your concrete before the #2007 becomes tack free. That will make it as if the curb and the concrete floor had been poured at the same time.
- An alternate method to this is to install concrete brick around the area bonding in place with Product #2006. This will help to reduce waiting for the concrete to cure if you use the poured concrete method above.
- Allow the concrete to cure – www.epoxy.comsurfaceprep.aspx.
- Cove the inside of the containment curb with Epoxy.com Product #720 – https://www.epoxy.com/720.aspx – coving resin allow to cure overnight.
- Prime the inside of the containment area with Epoxy.com Product #12– www.epoxy.com/12.aspx – Chemical Resistant Primer, and allow to cure overnight.
- Install 2 coats of Epoxy.com Product #633 – www.epoxy.com/633.aspx – Chemical Resistant Novolac Epoxy Coating.
Doing an effective job of building secondary is easier than you may think. For more information visit our website at http://www.epoxy.com, call our technical support department at 352-533-2167 or email us at firstname.lastname@example.org.