Poured Concrete Basement Waterproofing with Epoxy

September 18, 2014

This is the second half of a 2 part of a series on basement waterproofing with epoxy. In Part 1, we discussed waterproofing block wall foundations with epoxy. In Part 2A we discuss how to identify leaks that need waterproofing in basement walls, and floors that are made out of poured concrete. In this part (2B) will deal with epoxy injection repairs of cracks in poured concrete, that cause the leaks.

Earlier we discussed how many homes and businesses experience leaky basements year after year. The worse time is in the spring and after heavy rain. We discussed prudent things that you can do to improve drainage against your foundation. Epoxy Injection is designed to waterproof and give you the concrete’s structural integrity back.

Why Epoxy Inject the Cracks?

We discussed in our last article that cracking is a sign of failure caused by stresses, inadequate design, improper curing, etc. One of the dangers of a structural crack is the effect that it has on the reinforcing bar. The reinforcing represents one of the main structural values of the concrete. Cracks left unprepared allow water to enter your basement and attack the rebar.

Epoxy injection resin has two purposes:

  1. It effectively seals the crack to prevent the damaging moisture entry. Second, it monolithically welds the structure together.
  2. The injection also stops the infiltration of water into your basement.

Epoxy Injection Port Setting

Clean the concrete on both sides of the crack being careful not to force concrete dust into the crack. Concrete dust can be detrimental to the injection processes in several ways. Vacuum the area completely with a shop vac.

You need to determine the spacing of ports to be set. The spacing is a factor of the tightness of the crack and the depth of the concrete substrate. Spacing is normally between four (4) and eight (8) inches.

Port Setting and Sealing

Align ports directly over cracks. That allows injection resin to flow into the crack. Seal surface cracks and the ports in place. Sealing the exterior of cracks is done with Epoxy Gel #2006.

Selecting the Right Epoxy Injection Resin

Epoxy injection resin should typically be low viscosity injection resin- Epoxy Injection Resin #301. It must be low viscosity resin so it will flow in the smallest hair line cracks. Resin can travel several feet from the point of injection. It may take some time before reaching the next port or penetrating through pin holes in the surface. Epoxy injection effectively fills cracks including small voids and hairline cracks

Pumping Epoxy Injection Resin

The most economical way to deliver the epoxy injection is with the 450 ml binary injection system, a manual gun, or the pneumatically driven one. This uses a binary caulking gun with static mix tubes to inject the resin, insuring continuously mixed fresh material.

Limit pressure, low pressures allow gradual resin flow into the crack for deeper penetration. Start injection at the lowest point, and continues upward on the crack area. While injecting the lowest port, resin will flow to and out of the next higher port.

When pure resin is flowing out the next port cap, plug the current injection port and move to the next port. Then injection continues in the port showing resin flow. This procedure continues until all ports are full.

CONCLUSION

Epoxy injection is very effective at repairing concrete cracks and cutting of water infiltration. The right resin and equipment is critical. Epoxy injection makes a crack watertight while restoring the original structural integrity intended for the concrete. You can get all of the material you need to do this by contacting us:

321-206-1833 Customer Service – Ordering and Order Status
Katey Fontaine, VP – Customer Service Director
sales@epoxy.com

Technical Support
352-533-2167
Norm Lambert, President
Technical Support Director
info@epoxy.com

Additional Resources

http://www.epoxy.com/injection.aspx


%d bloggers like this: